Примеры использования Molar mass на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
But the above equation seems excessive for the analysis of the diluted gas, because for the diluted exhaust the molar mass of the dry air can be assumed.
For calculating the mass of NOx emissions, the molar mass of NO2 for the effective molar mass of all NOx species,
The molar mass of the exhaust gas shall be calculated according to equation 41 see paragraph 8.4.2.4.
In case of raw exhaust gas, the molar mass of the exhaust Mmix Mexh[g/mol] is recommended to be calculated as follows.
To do so either the molar mass, the density, or the molar volume of the corresponding liquid has to be known.
by multiplying it by emission molar mass, Mgas[g/mol];
This occurs because the molar mass of water(18 g/mol) is less than the molar mass of dry air around 29 g/mol.
The gas density gas[g/l] is calculated from the basic data molar mass Mgas[g/mol] and molar volume MVgas l/mol.
Optionally, the CO2 mass may be calculated in accordance with paragraph 8.4.2.4. of Annex 4 by using a CO2 molar mass(MCO2) of 44.01 g/mol.
inlet temperature, molar mass, and specific heat.
respective molar flow and by exhaust gas molar mass; then integration over test cycle shall be performed.
The authors show that all of the gases molar mass of which differs from the molar mass of nitrogen are the working bodies of the procedures for moving heat from the stratosphere to space.
Mmix, may be assumed for all calibration and all testing as long as assumed molar mass differs no more than +-1 per cent from the estimated minimum and maximum molar mass during calibration and testing.
also taking into account the molar mass of the ions, one can deduce F. The limit to the precision of the method is the measurement of F: the best experimental value has a relative uncertainty of 1.6 ppm,
temperature, and molar mass may change during an emission test,
Alternatively, the following exhaust gas molar masses may be used.
This annex uses the following molar masses or effective molar masses of chemical species.
Ratio between the densities(or molar masses) of the gas components
the Regulations specify effective molar masses based on assumed speciation rather than actual speciation.
The effective molar masses of THC and NMHC are defined by an atomic hydrogen-to-carbon ratio,