Примери за използване на Number of revolutions на Английски и техните преводи на Български
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
The performance of the pump design will depend on the number of revolutions of the working star.
During the execution of the work, it is not allowed to increase the number of revolutions, otherwise the drill may become hot,
with low number of revolutions(= low noise).
is in the mixer, you can practically in terms of the number of revolutions of the crane handle.
since the higher the number of revolutions, the clearer and more evenly in its structure.
allowing users to change the number of revolutions.
The ratio of the diameters of the pulleys is chosen so as to reduce the number of revolutions of the engine output shaft to 350 rpm.
It is a mistake to assume that the power of the drill depends on the number of revolutions per minute.
to reduce the number of revolutions of the stone.
However, in some cases, there is still a need to determine such an important parameter as the number of revolutions.
for work the number of revolutions rises to 13,000.
The high quality of work carried out with the grinder will depend on the number of revolutions of the cutting blade per 1 minute.
So, the power should be about 3 kW, and the number of revolutions- no more than 5000 per minute.
Particular attention to the power tool to its maximum size of holes and the number of revolutions.
Its capacity should be approximately equal to the limit of 2.5 to 3.0 kW, as regards the number of revolutions per minute, it should reach 1500.
Ideally, the gearbox should reduce the number of revolutions of the drill 5 times.
In order to carry out the process better and faster, the number of revolutions per minute must be reduced.
availability advantages become possible to regulate the number of revolutions.
For the assembly of such a device, an electric motor with a power of approximately 2 kW and more is needed, the number of revolutions is 1500.
A number of manufacturers offer miter saws, the number of revolutions of which can be adjusted depending on the type of work being done at the moment.