In the process you assign different hose groups to a specific working pressure and furthermore store the desired maximum and minimum permissible hose diameters for the selected hose groups.
The following limitations are present: maximum- this is the maximum screen resolution, and at minimum- this is 640 x 480 pixels(the minimum permissible mode of VGA adapters).
RangeMaxRatio, RangeMinRatio- the maximum and minimum allowable ratio of the channel range to the average range over the last 50 periods(e.g. RangeMaxRatio=0.6 means that the channel size must be less than 60% of the average range).
To base the page width on the width of the browser window, check Variable Width Page and enter values for Width(which controls where the vertical guide indicating the end of the page is placed) and Minimum which controls the minimum allowed width of the page.
Важно,これらの要件を満たすために、3Dモデル:最小許容肉厚と面-0,5ミリメートル,規範-
Important, 3d model to meet these requirements: the minimum allowable wall thickness
Though not an issue for the application in question(regulating a 12V battery down to 5V), the dropout voltage(minimum-allowed VIN minus VOUT) for this circuit equals that of the regulator IC(350mV maximum) plus the transistor's base-emitter drop of approximately 0.7V.
Maxlength& Minlength Options Maxlength and minlength are based on the HTML5 attributes of the same names that specify the maximum and minimum length allowed for input fields.
This may not damage the op amp, but if these signals are connected to terminals on other chips that haven't been fully powered(for example, assuming the ADC uses the same V+, and its power pin normally tolerates only -0.3 V minimum voltage), the chips may suffer damage.
許容最小曲げ半径15mmを実現。
An allowable minimum bending radius of 15 mm has been realized.
配線とビアに対する許容最小値。
Minimum Allowed Values for tracks and vias.
許容最小値は10秒です。
Minimum acceptable value is 10 seconds.
許容最小値は10秒です。
The minimum permitted value is 10 seconds.
許容最小ロゴサイズは90ピクセル(72dpi)が最小幅です。
Smallest accepted logo size is minimum width of 90 pixels(72dpi).
ひび、空気泡は縦および横のレベルの0-3mm両方の内で、厚さの許容最小になりません。
No crack, no air bubble, the thickness tolerances are minimized within 0-3mm both in vertical and horizontal level.
したがって、最小許容サイズは70x40cmです。
Thus, the minimum allowable size is 70x40 cm.
最小許容ループインピーダンスは23Ωです。
The minimum allowed loop impedance is 23Ω.
RAM:最小許容-512メガバイト。
RAM: minimum allowable- 512 MB;
高速道路上の最小許容速度-毎時60キロ。
The minimum permissible speed on expressways is 60 km/h.
速度制限最大値と最小許容速度。
Speed LimitsThe maximum and minimum allowable speed.
English
中文
عربى
Български
বাংলা
Český
Dansk
Deutsch
Ελληνικά
Español
Suomi
Français
עִברִית
हिंदी
Hrvatski
Magyar
Bahasa indonesia
Italiano
Қазақ
한국어
മലയാളം
मराठी
Bahasa malay
Nederlands
Norsk
Polski
Português
Română
Русский
Slovenský
Slovenski
Српски
Svenska
தமிழ்
తెలుగు
ไทย
Tagalog
Turkce
Українська
اردو
Tiếng việt