Output will be saturated when the current value exceeds the linear sensing range, and will return to normal output when the current value returns within the linear sensing range.
The basic system consists of(1)clamp sensor which is, under water, attached to the cable by a diver,(2)connecting cable, and(3)display unit which shows the current value on the ship.
Voltage divider top resistor value The voltage-divider top resistors, R1 and R5, need to be high enough so that the divider current is less than the minimum desired current value at MODSET or APCSET.
When the power is turned on, current begins to flow, and the initial current flow reaches the peak current value that is larger than the steady-state current value.
Thus when the analog output voltage is used to measure a certain current through the sense resistor, the microcontroller's ADC gives a current value between IEVALUATED(MIN) and IEVALUATEDMAX.
Output will be saturated when the current value exceeds the linear sensing range, and will return to a normal operation when the current value returns within the linear sensing range.
A transformer in series with the inductive plate, monitors thevalue of the current through the inductive plate in order to maintain the appropriate current value for the selected cooking level.
Cause(3) A current value below the minimum output current: When a V1(5V) output current is below the minimum output current with a multi-output power supply, there are cases where regular voltages are not being outputted with other outputs.
The raw data for each half-cycle are collected for both A and B sensors as 13 discrete current values measured as functions of time over the seven minutes providing a measured signal response curve, see, e.g., FIG.
Also, the heat dissipation from the capacitor to the outside air decreases(the thermal resistance increases) at high altitude or under reduced pressure and vacuum condition, so it is necessary to apply a certain derating to rated ripple current value of the catalog.
In the example of the figure, a circuit diagram is created to"ground the gate of a P-channel MOSFET, apply a voltage of 0 to 10 V in 0.1 V steps to the drain, and monitor the current flowing in the MOSFET at that time"; as a result of the simulation execution, a graph of current values is obtained the action of the blue arrow on the left.
English
中文
عربى
Български
বাংলা
Český
Dansk
Deutsch
Ελληνικά
Español
Suomi
Français
עִברִית
हिंदी
Hrvatski
Magyar
Bahasa indonesia
Italiano
Қазақ
한국어
മലയാളം
मराठी
Bahasa malay
Nederlands
Norsk
Polski
Português
Română
Русский
Slovenský
Slovenski
Српски
Svenska
தமிழ்
తెలుగు
ไทย
Tagalog
Turkce
Українська
اردو
Tiếng việt