英語 での Electrical resistance の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
For example, in the development of new materials, they are used when evaluating a material's electrical resistance.
Superconducting technology, notable for providing zero electrical resistance, enables a major reduction in line loss during power distribution, and its development for practical use in power lines as a beneficial environmental technology has been eagerly awaited.
This, in turn, has an electrical resistance that reacts to changes in temperature. Semiconductor sensors are used for this purpose, and these become more conductive when influenced by temperature, allowing a larger current to flow.
After action of electricity are significantly more affected plants in places with double aeration and seeding, with significantly lower electrical resistance of soil, and it will appear as over several days delay in growth.
The term refers to a phenomenon where high-frequency current flowing in a conductor does not penetrate to the interior but tends to flow only on the surface of the conductor. This drastically increases electrical resistance and therefore causes a drop in inductance.
As a high performance materials, pure tungsten has high melting temperature, high density, low vapor pressure, low thermal expansion combined with good thermal conductivity, sufficient electrical resistance, high modulus of elasticity.
Meanwhile, tungsten wire mesh is highly resistant to corrosion, it has high density, sufficient electrical resistance, high modulus of elasticity low vapor pressure and low thermal expansion combined with good thermal conductivity.
A lie detector finds out whether the suspect who committed a crime lies or not, so to speak, it was judging whether it is a lie or a truth from the heart rate and the electrical resistance of the skin.
In the aerospace industry, RAMDO can be of particular interest in the design of wings, engines, and interiors by taking into account the variability of materials, aerodynamic loads, electrical resistance, manufacturing, and operating conditions.
This pairing is unusual because electrons typically repel each other, but quantum physics overcomes this and, in so doing, reduces the electrical resistance in the superconductor to zero, or very close to zero.
Although the magnetization direction of the pin layer is fixed, the magnetization direction of the free layer changes according to the external magnetic field direction. The electrical resistance of the TMR element changes along with this change in the free layer.
Pin-type moisture meters: Invasive pins are pushed firmly into the surface of the substrate being measured and by measuring the electrical resistance between the pin electrodes provide the percentage moisture content(%MC) in the substrate.
It is a common theme to emphasize electrical resistance for good sound, but the electric resistance of the material itself is a fine numerical value as follows as compared with contact resistance and solder resistance. .
This material features high electrical resistance and outstanding magnetic characteristics in high-frequency range although saturation flux density is slightly lower than other soft magnetic materials.
When molecules adsorb on the receptor layer of the MSS, stress induced in the receptor layer causes electrical resistance change in the detection parts, enabling target molecules to be measured see the diagrams below.
It first became a transparent semiconductor, then it became a metal(when the temperature is lowered, electrical resistance is decreased), and in 2007, it also became a superconductor.
Repeating with a curvature of 2.5 mm, it was found that electrical resistance increased after about 20?30 times, but this was apparently because the PET substrate used as the base began to break down at this point.
My initial research involved motor development research using superconductive materials certain types of ceramics and other materials whose electrical resistance get extremely close to zero at ultralow temperatures.
Many people probably think that even if electrical resistance is zero, once it becomes necessary to bring in cooling devices, it is not cost-effective.
The pH and electrical resistance in the‘host'(infected) cells and tissues can be altered in such a way as to be unfavorable to virus replication.