英語 での Resistors の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
In this circuit, the output voltage, VOUT, is determined by the ratio of fixed resistors R1 and R2.
In effect, these resistors determine the degree of biasing on the chip's internal amplifiers.
Although he had yet to produce a single one of his resistors, Dr. Zandman was convinced that his theory would be successful.
These resistors are mainly used in auto engines and boiler ignition system.
The gate drive adjustment circuit and current detection resistors will be explained in Selecting Critical Components- MOSFET related -2.
But our internal limiting resistors limit the current to a safe discharge level.
Pull resistors can be used to define the default state which can then be overridden by a controller such as the XJLink2.
The expression for VOUT2_F is where RF1 and RF2 are the buffer feedback resistors and RIN1 and RIN2 are the buffer input resistors. .
Should be noted that will not need to use resistors due to the low voltages that works WRTNode.
Resistors are passive two-terminal components that resist the passage of electric current and dissipate power.
Eliminate the need for tapping wires to install the load resistors.
Figure 1 shows a simple application example that uses the MAX6956 to drive ten white and RGB LEDs without requiring current-limiting resistors.
Power resistors and chassis, thermostats and mating surfaces, and thermoelectric cooling devices.
Integrated Resistors The MAX5421(as an example) includes 15kΩ resistors and operates with a supply voltage of +5V or -5V.
There are four resistors in total-R1, R2, R3, and Rx-where Rx is an unknown resistance.
Viking has been offering customers high quality power resistors, power inductors and aluminum electrolytic capacitors with solid reputation.
To program a PDI microcontroller two external 510 ohm resistors are required.
Thin Film resistors are manufactured by processes that utilize minimal amounts of raw materials.
The output power can be varied with external resistors from +7dBm to +12dBm to compensate for loss in the external circuitry and cabling.
Power supplies with active-high enable inputs should have pulldown resistors, and power supplies with active-low enable inputs should have pullup resistors.