功率因数 - 翻译成英语

• power factor

在 中文 中使用 功率因数 的示例及其翻译为 英语

功率因数越接近1.00（100%），所述工作所需的电流量越低。
The closer the power factor is to 1.00(100%), the lower the amount of current needed to do said work.

目前就国内而言功率因数规定是必须介于电感性的0.9～1之间。
At present, the power factor regulations in China must be between 0.9 and 1 of the electrical sensibility.

对单个电器和家庭的历史测量证实了这一点，功率因数为0.9或更好，谐波失真相对较低[PDF]。
Historical measurements on individual appliances and homes have borne this out, with power factors of 0.9 or better and relatively low harmonic distortion[PDF].

据说在不久的将来，30-40w的led驱动适配器可能会有一些功率因数要求。
For 30W to 40W LED drive power, it is said that in the near future, there may be certain index requirements for the power factor.

但目前多数用於设计这些电源的标准设计，通常其功率因数仅在0.5至0.6的范围之间。
However, most of the current standard designs for designing these power supplies typically have a power factor of only between 0.5 and 0.6.

其主要功能有：基本测量参数：三相电压、电流、频率、有功功率、无功功率、功率因数、四象限电能、环境温度等九类，三十多个参数。
Basic measurement parameters: three-phase voltage, current, frequency, active power, reactive power, power factor, power four-quadrant, nine categories of environmental temperature, more than 30 parameters.

因此现在正是将功率因数修正（Power….
So now is the power factor correction Power..

一般出口LED平板灯功率因数要求达到0.85以上。
General export LED flat-panel lamp power factor requirements to achieve more than 0.85.

主要用于提高功率因数和改善电能质量。
These are mainly used for power factor correction and improving power quality.

一般出口LED平板灯功率因数要求达到0.85以上。
General Export LED flat lamp power factor requirements of more than 0.85.

五星级额定吊扇具有更高的功率因数。
The 5-star rated ceiling fans have a higher power factor.

一般出口LED平板灯功率因数要求达到0.85以上。
General export LED lamp power factor above 0.85 is required.

功率因数是电力系统的一个重要的技术数据。
Power factor is an important technical data of power system.

单相未修正的开关电源的功率因数通常相当差，如0.65。
Single phase uncorrected switching power supplies typically have fairly poor power factor, like 0.65.

PFC的英文全称为“PowerFactorCorrection“(功率因数校正)。
PFC English is called"Power Factor Correction", which means"power factor correction".

本系统使用非常高效的主动式功率因数校正(APFC)电源。
The system uses a very efficient Active Power Factor Correction(APFC) power supply.

这些异常可能包括低功率因数，电压变化，频率变化，和浪涌。
These abnormalities can include low power factor, voltage variations, frequency variations, surges, and sags.

存储电能的器件，一般用于功率因数校正和光源稳定控制。
A device for storing electrical energy, which is commonly used for power factor correction and light source stability control.

如果驱动功率因数过低，如0.6的功率因数，10W灯，就要消耗16W的功率。
If the driving power factor is too low, such as 0.6 power factor, then for a 10W lamp, it will consume 16W power,.

电动机是同步电动机，因此还可以提高电力线路的功率因数。
The motor is synchronous motor, so it can also improve the power factor of the power line.