输入电压 - 翻译成英语

• input voltage
• incoming voltage

在 中文 中使用 输入电压 的示例及其翻译为 英语

尤其是：在开机前要注意输入电压是否正常；.
In particular, we should pay attention to whether the input voltage is normal before starting the machine;

在这种特殊的应用中，无需将输出电压隔离于输入电压。
In this particular application, there is no need to isolate the output voltage from the input voltage.

额定输入电压：DC12V?
Rated voltage: DC12V?

输入电压100vac至240VAC.
Wider AC input range from 100VAC to 240VAC.

供电电压，VCC高于最高输入电压至少2伏。
The supply voltage, Vcc must be higher than the highest input voltage by at least 2 volts.

主输入电压也会影响UPS类型的选择。
The main input voltage may also influence the decision of UPS type.

输入电压：USB接口供电或者5V-12V外部电源供电。
Input voltage: USB interface power supply or 5V-12V external power supply.

图5显示各种不同输入电压下的效率曲线；.
Figure 5 shows the efficiency curve at various input voltages;

在输入电压一定范围变化时，都可以正常稳定工作;
When the input voltage changes within a certain range, it can work normally and stably;

提示：LM317的输入电压至少必须大于输出电压1.5V电压。
Note 1: The input voltage to the LM317 must be at least 1.5v greater than the output voltage..

较高的电压增益能够使其分辨出极小的输入电压之差。
Its high voltage gain enables it to resolve very small differences in input voltage.

通常负载允许的输入电压具有安全范围，例如标称值加或减5％。
Usually the input voltage allowed by the load has a safe range, such as the nominal value plus or minus 5%.

有些导航和信息娱乐系统采用5V或更高的输入电压工作。
Some navigation and infotainment systems operate from a 5 V and higher input voltage.

经整流和滤波的输入电压加在T1初级绕组的一端。
The rectified and filtered input voltage is applied to one end of the primary winding of T1.

注1：输入电压测量兜售高阻抗状态，SHDN或VCC=0V时。
Note 2: Input voltage measured with TOUT in high-impedance state, VSHDN or VCC= 0V.

系统电源为±5V，两个输入端的输入电压为VIN。
The power supplies of the system are±5 V and the input voltage at both inputs is VIN.

因为ADC的最大输入电压范围为6.6V，导致无噪声分辨率为：.
For the ADC's maximum input voltage range of 6.6 V this results in a noise-free resolution of.

通常负载允许的输入电压具有安全范围，例如标称值加或减5％。
The normal load allows the input voltage to have a safe range, such as the nominal value plus or minus 5%.

所有特性都与零的共模输入电压的测量，除非另有规定。
All characteristics are measured with zero common-mode input voltage unless otherwise noted.

如果输入电压下降到220V以下或上升到230V以上会发生什么？?
What does it happen if the supply voltage drops below 230V?