Exemples d'utilisation de Internal diameter en Anglais et leurs traductions en Français
{-}
-
Official
-
Colloquial
With the iglidur plain bearings, wear was determined via the internal diameter change in load direction.
All supply and return lines for the hydraulic oil must have a sufficient internal diameter and wall thickness.
The pipe can be rigid or not, with a minimum internal diameter of 16 mm.
After removal of the protection cap, a hose with internal diameter of 35 mm can be attached.
frames 49mm internal diameter straight headtubes.
Standing model with boot Bbyrgbi0jz The machine is prepared for the use of eyelets with 2 mm internal diameter.
attic, to provide access for 100mm internal diameter ducting.
All supercharged diesel engines must be fitted with an air restrictor with a maximum internal diameter of.
Connect the water drain hose to a stand pipe with vent-hole minimum internal diameter 4 cm.
The 28 adapter sleeve reduces the 30 mm internal diameter of the aluminium clamp to the standard 28 mm tube size.
Measure the internal diameter of each cylinder at a location approximately 19 mm(0.75 inch) from each end of the cylinder bore,
This hose has an internal diameter of 16 mm., is tasteless,
If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided.
When the non-standard O-ring internal diameter is over 2.2m, two or more smaller rings
20 tunnel diameters downstream of the exhaust gas inlet to the tunnel and have an internal diameter of at least 12 mm.
Design ducts with appropriate internal diameter(increasing as one approaches the de-dusting system) in order to maintain adequate transport velocities
1 key segment, with an external diameter of 7620 mm, an internal diameter of 7010 mm,
The internal diameter of the pipes has to be respected to avoid untightening
Where the drainage pumps are connected to a drainage system the drainage pipes shall have an internal diameter of at least d1, in mm, and the drainage spurs an internal diameter of at least d2, in mm.
adjacent sizes may be usable as there is some crossover in the range of each model as shown in the internal diameter range.
