时钟信号 in English translation

• clock signal
• clock signals

Examples of using 时钟信号 in Chinese and their translations into English

思科在报告中提道：“在某些设备单元中，我们已经看到时钟信号分量随时间降级。
Cisco wrote:“In some units, we have seen the clock signal component degrade over time.

然而，同步这个术语在此并不精确，因为数据以非同步格式传输而不包含时钟信号。
Unfortunately the term synchronous is imprecise since the data is transmitted without a clock signal in an asynchronous format.

驱动CS为低电平，并在SCK端施加时钟信号，从SO读取结果。
Force CS low and apply a clock signal at SCK to read the results at SO.

地址、数据输入和其它控制信号均于时钟信号相关。
Addresses, data inputs, and other control signals are all related to the clock signal.

不需要时钟信号.
No clock signal needed.

在微机中产生时钟信号。
A clock signal is generated in the microcomputer.

不要将时钟信号靠近电路板边缘.
Do not route clock signal close to the board edge.

HSE:高速外部时钟信号，精度高。
HSE= high-speed external clock signal.

因此，无需从外部提供时钟信号。
No external clock signal is necessary.

所有寄存器接受同一个时钟信号.
All devices use the same clock signal.

外部时钟信号直接施加到OSC1引脚。
External clock applied to the OSC1 pin.

时钟信号(scl)生成由主设备执行。
The clock(SCL) signal is generated by the master device.

也就是说数据的传输没有时钟信号。
Data that is transmitted without an associated clock signal.

时钟信号总是由设备端生成的。
Note that the clock signal is always generated by the keyboard.

UART是一种异步协议，意味着没有时钟信号。
UART is an asynchronous protocol which means there is no clock signal.

新的时钟源准备好之前时钟信号不会被切换。
The clock signal is not switched until the new clock source.

使用嵌入式时钟信号，具备了更强的纠错能力;
The SATA bus uses an embedded clock signal and has a stronger error correction capability.

Fly-by信号是命令、地址，控制和时钟信号。
The fly-by signals include the address, control, command, and clock routing.

我们为避开外部时钟信号而采用的这些机制是-.
These mechanisms, which we get for eschewing the external clock signal, are-.

新时代的作用是为系统提供基本的时钟信号。
The main function of this circuit card is to supply basic clock signals to the system.