电弧 in English translation

• arc
• arcing
• electric

Examples of using 电弧 in Chinese and their translations into English

当电极之间形成电弧时，电弧塔的温度可以达到3000〜6000K，适合于金属的高温熔化。
When an arc is formed between the electrodes, the temperature of the arc column can reach 3000-6000K, which is suitable for high-temperature melting of metal.

一种危险条件，触点或设备故障可导致触电、电弧闪光烧伤、热烧伤或爆炸。
A dangerous condition in which contact or equipment failure can result in electric shock, arc flash burn, thermal burn, or blast.

当局部电弧或故障的电气设备内发生，这会导致的分解产物的生成，如二氧化硫和氟化氢。
When partial arcing or a failure occurs within electrical equipment, this can cause the creation of decomposition products such as sulphur dioxide and hydrogen fluoride.

巴基斯坦钢铁行业主要由小型和中等规模的再轧厂，从事再轧，锻造和电弧炉熔炼活动。
The steel industry in Pakistan is dominated by small and medium-scale re-rolling mills, engaged in re-rolling, forging and arc furnace melting activities.

虽然电弧往往是隔离和局部的，但对轴承的影响几乎就像是一系列小的雷击，他说。
Although the arcing tends to be isolated and localized, the effect on the bearing is“almost like a series of little lightning strikes, he says.

在家里，谢里登毕业生可在工作室，包括大师，Corus公司，杯茶咖啡和电弧，等找到。
At home, Sheridan graduates can be found at studios including Guru, Corus, Cuppa Coffee, and Arc, among others.

金属球式倾斜开关的另外一个缺点在于它在没有经历电弧放电问题的情况下，无法操作2安培以上的负荷。
Another disadvantage of metallic ball tilt switches is that they cannot handle loads greater than two amps without experiencing arcing issues.

一种危险条件，触点或设备故障可导致触电、电弧闪光烧伤、热烧伤或爆炸。
A dangerous condition such that contact or equipment failure can result in electric shock, arc flash burn, thermal burn, or blast.

为了均匀分布微放电，必须使用介电绝缘体来分离金属电极并防止电弧放电。
In order to evenly distribute the micro discharges, a dielectric insulator must be used to separate the metallic electrodes and to prevent arcing.

在配电室（箱）处切断电源时，面孔应背向闸刀，防止电弧击伤。
When the power is cut off at the power distribution room(box), the face should be facing away from the knife to prevent arc injury.

在触点闭合和打开期间，存在许多特殊的物理和化学现象，例如接触接触电阻，接触抖动和电弧放电。
During the closing and opening of the contacts, there are many special physical and chemical phenomena, such as contact contact resistance, contact jitter and arcing.

本标准适用于下列照明产品：金属卤化物灯或电弧管；短弧汞灯；短弧氙灯；.
This standard applies to the following lighting products: metal halide lamps or arc tubes; short arc mercury lamps; short arc xenon lamps;

元件或电路板走线上的跟踪或电弧标记表明污染失败的证据。
Tracking or arcing marks across components or circuit board traces indicate evidence of contamination failures.

只要这时能维持一定的电压，放电过程就能连续进行，使电弧连续燃烧。
As long as a certain voltage can be maintained at this time, the discharge process can be continuously performed to continuously burn the arc.

在触点闭合和断开的过程中，会伴随着很多特殊的物理和化学现象，如触点接触电阻、触点抖动和电弧等。
During the closing and opening of the contacts, there are many special physical and chemical phenomena, such as contact contact resistance, contact jitter and arcing.

但研究人员希望进一步推广这项工作，使之与其他光源一致，如led、萤火虫或电弧。
But the researchers hope to generalize the work further to agree with other light sources, like LEDs, fireflies or arcing bolts of electricity.

当然，电弧不能打得太深，否则皱纹很容易由标签本身的问题引起，这增加了不必要的麻烦。
ARC may not be going too deep or because the issue can easily lead to fold the label itself, add unnecessary trouble.

等离子电弧的引入革命性地提高了切具的速度、准确性以及切割种类，并且可应用于各种金属。
The introduction of plasma arcs revolutionizes cutters' speed, accuracy and cutting variety, and can be applied to a variety of metals.

这些快速过压瞬变存在于所有配电网络上，并且可能由内部或外部事件引起，例如闪电或电机电弧。
These rapid voltage spikes are present in all distribution networks and can be caused by internal or external events, such as lightning or motor arcs.

电弧是一种经过气体放电的现象，在两个电极之间的空气空隙中发生耐久而激烈的放电现象，称为焊接电弧。
An electric arc is an air-conducting phenomenon that produces a strong and long-lasting discharge phenomenon between two electrodes, called an electric arc.