Examples of using Two nuts in English and their translations into French
{-}
-
Colloquial
-
Official
Minimum distance: the lifting rollers must never come into contact with each other!- Lock the threaded rod again after setting by tightening the two nuts(2) together.- Retighten two hexagonal bolts 1.
top position with the two screws, then secure the flue collar to the rear with the two remaining screws and two nuts.
was inspected after landing, half of one of the balance weights from the rightside elevator spring tab, and the two nuts that secure it were missing.
leaving enough space for the spring to pivot freely between the two nuts.
Reinstall the rear bottom plate by fitting the back edge of the plate into the channel located on the back of the hood and reinstalling the two nuts and washers removed in Step 1 Figure 5.
there are two nuts in each cupule, maturing in the autumn 6-7 months after pollination.
by the means of two bolts(O) and two nuts N.
adjust the direction by always screwing inwards one of the two nuts no. 1.
Tighten the two nuts(B) Fig. 41 to hold the housing in place.
Tighten the two NUTS ON STUDS FIRST and tighten the NUT ON BOLT LAST.
which were two NUTS III subdivisions as well as parts of Ave Subregion and Tâmega Subregion.
Install two nuts(D) and tighten.
Fit the two nuts over the screws.
Loosen the two nuts C, Figure 18.
Only two nuts are needed on this model.
Tighten the two nuts on the drawbar bracket.
Remove the two nuts holding filter onto machine.
Remove two nuts(C) and screen retainer.
Raise the handle and tighten the two nuts 2.
Mounting device with M4 set screw and two nuts.