Examples of using Ethernet interfaces in English and their translations into German
{-}
- 
                        Colloquial
                    
 - 
                        Official
                    
 - 
                        Ecclesiastic
                    
 - 
                        Medicine
                    
 - 
                        Financial
                    
 - 
                        Ecclesiastic
                    
 - 
                        Political
                    
 - 
                        Computer
                    
 - 
                        Programming
                    
 - 
                        Official/political
                    
 - 
                        Political
                    
 
In addition, these new SMARC 2.0 modules have two gigabit ethernet interfaces that offer hardware-based real-time support through precision time protocol PTP.
Terminal devices with serial and Ethernet interfaces may communicate within an Ethernet 
The advantages described can also all be enjoyed to the same extent when using Ethernet interfaces with higher bandwidths e. g.
Observe which Ethernet interfaces(ethX) have been assigned to the type of Gigabit NIC that is connected to the Gigabit switch.
Determine which Ethernet interfaces(ethX) have been assigned to the type of Gigabit NIC that is connected to the Gigabit switch.
Two Ethernet interfaces yield greater precision.
Improved configuration of Ethernet interfaces on VN8900.
With additional Ethernet interfaces, USB ports or PROFIBUS.
Two Gigabit Ethernet interfaces are available to connect to the network.
Up to 10.000 measurement results storage downloadable through USB or Ethernet interfaces.
seamlessly connect multiple LANs via scalable Ethernet interfaces.
Note: USB Ethernet  adapters can be found in the section listing Ethernet interfaces.
secure implementation of common fieldbus and Industrial Ethernet interfaces.
Parameters can be quickly exported to other devices using the internal system bus or Ethernet interfaces.
Load balancing is a feature which distributes the workload evenly across two Ethernet interfaces for higher redundancy.
The standard variant of XC300 has three independent Ethernet interfaces which enable the use of different network addresses.
The up-to-date tutorial explains which fieldbus and Ethernet interfaces are available in PAS4000 and how to configure them.
Network-autoconfig makes sure that during firstboot all available ethernet interfaces are cycled until one is successfully configured with DHCP.
the Commandline Feedback window list the available Ethernet interfaces with their IP address.
Up to five Ethernet interfaces, four with 10Gb and one connection with 1Gb transfer rate, provide high network bandwidth.