Examples of using Camera body in English and their translations into Polish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Financial
-
Official/political
-
Programming
-
Computer
Answer: To connect a manual lens with a T2 thread and a camera body, you must have the correct T-2 ring.
The male pogo connector attaches to the camera body without tools and the Male LEMO connector attaches to the original RED LCD/EVF using the standard 16pin LEMO connector.
The male pogo connector attaches to the camera body without tools and the female pogo connector has a slotted design that can be bolted to any two 1/4-20 screws holes up to 54mm apart,
then removing the portion of the camera body that needs to come off in order to access the IR board, you will need
or dial in yourself on the camera body in A or M modes. EXIF data such as lens identification, focal length and aperture.
controls that are nearly the same as those on the back of the camera body.
while the contact surface with the camera body uses an aluminum component similar to that used in XF lenses.
or dial in yourself on the camera body in A or M modes. EXIF data such as lens identification, focal length and aperture.
Using the Boost Mode in the Vertical Power Booster Grip(VPB-XT2, optional) *2 A computer-controlled system that applies thin layers of ultra-fine particles while rotating the camera body at high speed.
so lens functions that rely on electronic communication with the camera body(autofocus, AE metering,
light level), the camera body and lens combination,
thread and a T2/ Canon ring that allows the Canon EOS camera body to be mounted for other DSLRs a dedicated T-ring is needed.
For use on X-mount camera bodies.
I have two Nikon camera bodies(D4 and D810)
To be fully compatible with the AF system on this lens, the Fujifilm X Mount camera bodies listed below will require a firmware update, which is scheduled
Contrast of the upper control plate against the camera body.
Three coats are applied to the camera body, as follows.
DC power is supplied by the camera body via the hot shoe connector.
Optimum balance with sufficient clearance from the base of the camera body when using a large-diameter lens.
The supplied adapter with photo thread allows you to attach directly to the DSLR camera body or CCD camera eyepiece.