Examples of using Rolling process in English and their translations into Portuguese
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Ecclesiastic
-
Computer
-
Official/political
corners and surfaces during your rolling process to improve temperature uniformity
The following figure is pure molybdenum plate and molybdenum rhenium alloys(3% Re) plate rolling process of annealing treatment on tensile strength and elongation diagram.
rebar are produced in hot rolling process from steel billets.
Due to our adoption of hot rolling process, the original casting structure of the steel slab for making hot rolled pipe is destroyed.
The hot rolling process of titanium alloy is different from the traditional cold extrusion forming process. .
Rolling process, annealing treatment embodied in tensile strength with increasing temperature,
the microsim¿,to calculate the evolution of grain sizes along the rolling process.
consecutive semi-continuous rolling and rolling process.
the hot torsion test is an effective method to simulate the hot rolling process.
For example, the production of high strength titanium alloy tubes by a direct cold rolling process can not only greatly reduce the production cost, but also meet the
performance of the slab, special rolling process to produce molybdenum plate,
Standard-strength steel is formed by the rolling process and provides 758 Mpa(110,000 psi) minimum yield strength
When the conditions of interpass heat treatment and the subsequent rolling process are the same, the microstructure distortion of the tube obtained from rolling with large deformation is more serious.
This model Electric Calender is mainly used for small electrodes in the rolling process, suitable for use by universities and enterprises experiment line,
Double roller method in the production of glass are divided into half continuous rolling and continuous rolling process, by water glass a pair of rollers,
the rolling mill plate work area around the titanium plate rolling process focuses and difficulties to carry out research,
During the rolling process, the deformation of the two sides of the rich alpha layer is not harmonization,
The advanced equipment, rolling process, process control,
In this dissertation, results of the study of the microstructural evolution of a duplex stainless steel uns s32205 during the cold rolling process and further isothermal annealing at 1080ºc are reported.
in the road between the same heat treatment conditions and the subsequent rolling process, the large amount of deformation on billet obtained tube distortion more serious.