Examples of using Input current in English and their translations into Russian
{-}
-
Official
-
Colloquial
The limits for single phase or three-phase ESAs in configuration"REESS charging mode coupled to the power grid" with input current<= 16 A per phase are given in Table 10 of paragraph 7.11.2.1.
The limits for three-phase ESAs in configuration"REESS charging mode coupled to the power grid" with input current> 16 A and<= 75 A per phase are given in paragraph Table 12 of 7.11.2.2.
If measurements are made using the method described in Annex 11, the limits for input current> 16 A and<= 75 A per phase are those defined in IEC 61000-3-12, and given in given in Table 4, Table 5 and Table 6.
For three-phase"RESS charging mode coupled to the power grid" with input current> 16 A and<= 75 A per phase, when at least one of the three conditions a, b, c described in IEC 61000-3-12(edition 1.0- 2004)
For three-phase"REESS charging mode coupled to the power grid" with input current> 16 A and<= 75 A per phase, when at least one of the three conditions a, b or c described in clause 5.2. of IEC 61000-3-12 is fulfilled,
The input current of each phase is measured with the aid of the built-in current transformers to which the requirements of the high linearity in the range of the current values from the threshold of sensitivity to the maximum acceptable values are made as well as the strict requirements to the value of the phase displacement.
For three-phase ESAs in configuration"REESS charging mode coupled to the power grid" with input current> 16 A and<= 75 A per phase, when at least one of the three conditions a, b or c described in clause 5.2.
The input current of each phase is measured with the aid of the built-in current transformers to which the requirements of the high linearity in the range of the current values from the threshold of sensitivity to the maximum acceptable values are made as well as the strict requirements to the value of the phase displacement.
described in Annex 11, the limits for input current> 16 A and<= 75 A per phase are those defined in IEC 61000-3-12,(edition 1.0- 2004) and given in given in Table 4, 5 and 6Table 4, Table 5 and Table 6.
The message[INPUT CURRENT PASSWORD] will be shown.
The message'INPUT CURRENT PASSWORD' is displayed.
Inputs currents against currents and voltages.
then the password error message will be displayed for 5 seconds before the screen shows the INPUT CURRENT PASSWORD.
lasting for 5 seconds, and the message'INPUT CURRENT PASSWORD' is displayed for your retry.
and the message'INPUT CURRENT PASSWORD' displays for your retry.
Typical Harmonic Contents of Input Current for 18-pulse System.
IEC 61000-3-12(edition 1.0- 2004) for input current in charging mode> 16 A and.
Besides, the factor of harmonics of an input current and input electrical power factor essentially improve.
Current sensor is designed to convert current input signal to level signal proportional to the input current in the recovery mode.
A line of positive slope may be used to reflect the increase in firing rate that occurs as input current increases.