Examples of using Electrode diameter in English and their translations into Spanish
{-}
-
Colloquial
-
Official
Solution Use a smaller diameter electrode.
Up to 3.25mm diameter electrode welding is possible in MMA.
The smallest diameter electrode which can carry the required current should be used.
The diameter of an electrode always corresponds to the diameter of the soul.
Weld bead width is typically twice the diameter of the electrode.
KP665-045C Drive Roll- Optional- Knurled drive roll for feeding .035 .045(0.9- 1.2 mm) diameter flux-cored electrode.
The diameter of the electrode to use is directly proportional to the current being used for welding.
The advancing speed shall be proportional to the diameter of the electrode and the surface to cover;
In the MMA process it allows you to switch between two different parameter setup modes automatic, to select the type of electrode and diameter, or manual.
Adjust the welding current according to the diameter of the electrode and the thickness of the piece to be welded.
If you are using gas-lens type accessories, the gas flow may be reduced to approximately 3 times the diameter of the electrode.
If you are using gas-lens type accessories, the gas throughput may be reduced to approximately 3 times the diameter of the electrode.
attempt to keep it a distance from the workpiece equivalent to the diameter of the electrode.
immediately raise the electrode a distance equal to the diameter of the electrode or it will stick to the surface.
The parameters of the welding(diameter of the electrode, current amperage…)
workpiece holder ISO 40, outside diameter rotary electrode 150 mm x 60 mm,
Once the arc ha started, the electrode is held at a distance that is approximately equal to the diameter of the electrode itself, and the advance of the weld is initiated by pulling backwards as if a righthanded occidental person was writing.
Insert which can accept 15mm diameter electrodes.
The major diameter electrodes are selected for the welding of materials of great thicknesses
Cable with“electrode holder” gun is connected to terminal(4) for electrodes having a diameter equal or smaller than 3.2mm,