Examples of using Red LED flashes in English and their translations into Spanish
{-}
-
Colloquial
-
Official
During the next 6 seconds(the red LED flashes fast while the display shows Pairing)
Make sure the vane is pointing due north at the moment when the red LED flashes and the calibration is now completed.
the connected lighting switches ON for 2 seconds and the red LED flashes slowly.
keep pressing the C1 button until the red LED flashes three times.
5 minutes red LED flashes slowly for channel 1.
5 minutes red LED flashes slowly during this period.
Press the monitor key to end this setting. The red LED flashes two times.
5 min. red LED flashes slowly during this period 4 Installation/ connection Note.
Red LED flashes for 50 VAC RMS
When the transmit timer is about to expire, the red LED flashes and the radio gives three beeps.
charging is discontinued and the red LED flashes.
Then the SEO 7R can not be turned on again but the red LED flashes for a short moment to indicated that this function is activated
the green LED shines and- the red LED flashes with 5 Hz,- the red LED flashes with 1 Hz,- the red
Alarm condition: If an alarm condition occurs the pump will drive stop running. The red LED flashes continuously to indicate the presence of an alarm.
time Yellow LED ON/OFF: indication of relay output Red LED ON/OFF: indication of failure of the corresponding threshold Red LED flashes: indication of tripping delay of the corresponding threshold 4.
Red LED, flashes during a call.
Red LED flashing every 0.5 seconds Off.
Internal electrical fuse has been activated red LED flashing rapidly.
Red LED flashing 1 beep every 5 seconds.
TIMER(red LED flashing) Auto switch-off after 15 min.