Examples of using Slave device in English and their translations into Spanish
{-}
-
Colloquial
-
Official
Edge gateway can access any data within any EtherCAT slave device via the mailbox gateway feature of the EtherCAT master.
ADS over EtherCAT(AoE) A slave device isn't required to support all communication profiles;
All slave devices then work synchronously with the master device. .
Connection protocols of slave devices to the CAN and EtherCAT fieldbus;
Connect up to seven slave devices to each Anybus Wireless product.
The master requests information from the slave devices, which can number up to 247.
The slave devices will automatically follow the master device upon connection.
It can be very helpful for developers working with Modbus slave devices.
Grey(middle) connector- is used for slave devices on the cable.
This driver is intended for serial communications with slave devices only.
It is common for slave devices to convert these larger data types into registers.
If slave devices are connected to the CANopen bus,
Simple slave devices don't even need an additional microcontroller,
If multiple slave devices are assigned addresses in the same area,
For more complex slave devices, the communication performance depends only minimally on the microcontroller performance,
Communication profiles In order to configure and diagnose slave devices, it is possible to access the variables provided for the network with the help of acyclic communication.
The master device doesn't require a special interface card and the slave devices use highly-integrated, cost-effective chips available
The slave devices only serve to register the presence of persons- if motion is detected they send an impulse to the master.
The DS2482-100 provides bi-directional protocol conversion between the I2C port on the Raspberry Pi and any attached 1-Wire slave devices.
The Modbus protocol uses four distinct tables to store data in the slave devices.