Примеры использования Measured value block на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
Measured value block 03- Diagnostic wire.
Measured value block 58: Date.
Measured value block 57: diagnosis.
Measured value block 5 shows a fixed value of -2.5°.
Measured value block 12 should show a signal voltage of DC 1V.
Measured value block 12 should show a signal voltage of DC 1V.
These measured values are located in measured value block 62 zones 3 and 4 of the.
The sender temperature data are displayed in measured value block 4- positions 2 and 4.
Measured value block 10 as per Workshop Manual
At temperatures above +60°C and below -40°C a value of -50°C is displayed in measured value block 4. But there is then no fault memory entry on the dash panel insert.
The request determined by the Climatronic control unit -J255 is displayed in the measured value block.
remaining battery time can be checked in the measured value block.
item following contact with water and a negative test in measured value block 10.
the pressure calculated by the Climatronic control unit -J255 are indicated in the measured value block(display group 1).
remaining battery time can be checked in the measured value block.
Depending on the engine control unit version, the signal is displayed in the measured value block as a duty cycle.
J Activation of the AC compressor regulating valve -N280- is indicated in the measured value block of the onboard power supply control unit -J519-(address word 09 measured value block 34).
J If the connector of the vehicle body acceleration sensor is horizontal, measured value block 12 should show a signal voltage of DC 1.56 V.
J If the connector of the vehicle body acceleration sensor is horizontal, measured value block 12 should show a signal voltage of DC 1.56 V.