英語 での Analog switches の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Its V+ pin must be connected to the CP pin of the DS2784 so that the analog switches can pass the high voltage gate drive from the discharge-control(DC) and charge-control(CC) pins to the protection FETs.
Figure 1.A simplified diagram of a CWD delay-line-based receiver. This architecture is relatively easy to implement in a compact system since it relies on easy-to-integrate voltage-to-current converters, analog switches, a few passive delay lines, and a single I/Q mixer pair.
MAX4885E Ultra Low-Capacitance VGA Switch with±15kV ESD- Maxim Description Create a design and simulate using EE-Sim® tools: The MAX4885E integrates high-bandwidth analog switches and level-translating buffers to implement a complete 1:2 multiplexer for VGA signals.
12-bit DAC, analog switches, and GPIO.
12-bit DAC, analog switches, and GPIO.
MAX14594E High-Density,±5V Capable DPDT Analog Switches- Maxim Description Create a design and simulate using EE-Sim® tools: The MAX14589E/MAX14594E high-density, double-pole/double-throw(DPDT) analog switches feature Beyond-the-RailsTM signal capability that allows signals from -5.5V to +5.5V to pass without distortion even when the power supply is below the signal range.
The analog switch connects either one device or the other.
Analog switch matrix.
Analog Switch/Multiplexers(20).
Dtouch series completely cancels the analog switch, and the noise processing capability is stronger.
MOSFETs internal to the analog switch turn on when the battery voltage exceeds 1V.
The negative charge pump and the analog switch can be used to improve performance in audio/video applications, as discussed in the following text.
The MAX865 dual-output charge pump(IC1) provides a local bipolar power supply for the MAX4659 CMOS analog switch IC2.
Description The MAX9503/MAX9505 DirectDrive video filter amplifiers integrate an analog switch(MAX9505 only) and a negative charge pump.
The analog switch has a bandwidth of 200MHz and can be used to switch the video signal.
To select between the devices, the master device sets a port pin to control the state of the dual SPST analog switch.
Using the MAX4659 CMOS analog switch results in a switch on-resistance of less than 30Ω, a transition time of less than 200ns, and low leakage current.
The pass element in an analog switch contains one or more MOSFETs and has parasitic clamping diodes to the supply voltages for ESD protection.
Adjacent pairs of ports are configurable as a logic-level translator for open-drain devices or an analog switch.
The MAX14760 is a single-pole/single-throw(SPST) analog switch, while the MAX14762 is a dual-SPST analog switch. .