英語 での Resistance value の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Purity of the single and multi-crystalline silicon material in response to customer requests, resistance value, we offer you is processed into a size and shape.
Wattage of protective series resistance RS>(load current)2 x series resistance value RS.
Cu/ Ag composite plating particles can reduce powder resistance value by 90% for Ni plating particles.
Both part numbers are identified by the series, size, tolerance, packing type, temperature coefficient, taping reel and resistance value.
The rate at which resistors divide the voltage is equal to the ratio of the resistance value.
The detection time of the overcurrent protection circuit can be adjusted by the resistance value connected to the TBLANK pin.
The resistance value seen from the input and output terminals. Used only when describing nominal values of input/output resistances. .
It is the maximum allowable power that can be applied continuously. The input voltage that can be applied can be obtained if the resistance value is determined.
Two element RM has resistance value in its part number. How about 3 element or more?
We cannot recommend a long length since a longer length has a bigger roundtrip resistance value, which is a factor in measuring errors.
The code that determines the resistance value is specified by the variable[REGISTER_CODE].
At room temperature and normal humidity to 500VDC voltage insulation resistance value between the two loop detection.
Resistance value is mesaured by using pectinate gold plating basal plate made by Polymatech Japan.
By reading this resistance value, fluctuations in air pressure can be measured.
Jumper use with resistance value lower than 0.3mΩ YJP~0.3m ー ー.
(3) Recording of resistance value for 1 second before and after event occurs in 10 ms intervals for up to 200 times.
Convert to DC signal in proportion to temperature by insulation with resistance value of 3 wire system resistor bulb as input.
The lower the resistance value, the higher the conductivity of the surface and the effect of suppressing the charging of static electricity.
This is suitable for heaters that use silicon carbide and SILICONIT where the resistance value increases with the temperature change and secular change.
The resistance value of MR2 increases, and it will be able to be understood by this that an output voltage grows big.