英語 での The bracket の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
The bracket can be flexibly adjust up, down, left and right.
Prevent the bracket loose design, use it more smooth and flexible.
Preheat the bracket with a soldering iron and gently fuse it into the bumper, bending the ends from the inside.
If you choose the bracket, you can adjust it according to the height you want, or you can get tired.
To remove the bracket, perform the steps for securing it in opposite order.
If you cannot get the R-Clip through, you may need to remove the bracket from the tank.
For exact results large in magnitude, one of the endpoints of the bracket may be infinite.
The bracket should fit so the XLR connector faces the rear of the microphone, and the Shure logo on the back of the microphone is right-side up.
Connect the wooden leg to the bracket using the 2 lower-most holes in the leg and bracket. .
The bracket is usually made of lace material, so it is good to wear lightly without sweat.
Remove the four Y000 screws securing the bracket over the home/Touch ID sensor.
The bracket is fastened to an M16 bolt cast in situ, embedded 300 mm into the armor-plated real block wall.
Since it energized only by inserting the bracket to the base hole, it can be very functional and this can be made excellent design created.
Use caution to ensure that the bracket does not pre-load pump/P.T.O. mounting.
Depending on the patients, at first the following device is prepared to move the teeth roughly, then the bracket will be set up.
To the left and right ear、It is thrust into the bracket, such as a small funnel。
To avoid pressed the battery replacement switch when you turn on the light, the bracket would cover the replacement key.
Safe quick change of tube and collar by just pull out the bracket.
Adapt measures to local conditions: The installation site of each Off gird solar systems project puts forward different requirements for the bracket.