在 英语 中使用 Routing protocol 的示例及其翻译为 中文
{-}
-
Political
-
Ecclesiastic
-
Programming
RSVP is not a routing protocol and was designed to interoperate with current and future routing protocols. .
Its multi-access nature also introduces design considerations pertaining to the mapping of routing protocol adjacencies that should not be overlooked.
NOIA combined Segment Routing protocol, Distributed Ledger Technology and built the proof of concept(PoC).
A routing protocol that makes up for some of the limitations of RIP and can coexist with RIP on a network.
The Exterior Gateway Protocol(EGP) is a now obsolete routing protocol for the Internet originally specified in 1982 by Eric C….
Routing Protocol(RIP) of the number of hops that must pass before the destination gateway number, RIP acceptable to jump the longest distance is 15.
Similarly, each autonomous system can have its own internal routing protocol for routing data within its own network.
RIP is the simplest of dynamic routing protocols and is used in this section to provide a basic level of routing protocol understanding.
ATM is differing from TCP/IP because it use fixed channel routing protocol routes between two end points.
Multicast Source Discovery Protocol(MSDP) is a Protocol Independent Multicast(PIM) family multicast routing protocol defined by Experimental RFC 3618.
All link-state routing protocols apply Dijkstra's algorithm to calculate the best path route.
Routing protocols determine the best path, or route, to each network.
The two original IPv4 routing protocols developed were RIPv1 and IGRP.
There are only two link-state routing protocols, OSPF and IS-IS.
The four main types of routing protocols that are used in RRAS are.
Multi-path routing can be used in conjunction with most routing protocols, because it is a per-hop decision limited to a single router.
Routers run routing protocols which constantly check on the availability of routes to all known IP destinations.
(routing protocols like OSPF, which run over IP, may also be considered part of the Network layer).
Link-state routing protocols allow you to assign a link cost for each link to identify the path length of a link.
The router or multilayer switch must also support the routing protocols being used in the core.