在 英语 中使用 The carbon content 的示例及其翻译为 中文
{-}
-
Political
-
Ecclesiastic
-
Programming
This exothermic reaction is used in the iron and steel industry to control the carbon content of steel.
这一放热反应应用于钢铁工业中，用以控制钢铁的碳含量：.Land degradation, does not only reduce crop yields but often reduces the carbon content of agro-ecosystems, and may reduce biodiversity.
土地退化不仅降低了作物产量，还频繁减少了农业生态系统的碳含量，并可能减少生物多样性。In order to ensure its toughness and plasticity, the carbon content is generally not more than 1.7%.
为了确保其韧性和可塑性，碳含量通常不超过1.7％。The carbon content of the carbon increases the graphite structure of the carbon and enhances the electrical conductivity.
碳的碳含量增加了碳的石墨结构并增强了导电性。Generally, the carbon content of steel can be reduced by less than 0.03% to meet the requirements of intergranular corrosion resistance.
通常钢中合碳量降至0.03%以下即可满足抗晶间腐蚀性能的要求。废钢熔化，杂质被氧化，并且碳含量由90%减少，导致钢液。Because the carbon content of fuel varies, certain fuels should be taxed at a higher rate.
因为燃料的碳含量各有不同，某些燃料的税率就应该高一些。The carbon content of spheroidal graphite cast iron exceeds 3%, which is far higher than the carbon content of cast steel.
球墨铸铁材质的含碳量超过3%，远远高于铸钢的含碳量。It is characterized by the carbon content of less than 0.1%, using Cr, Ni with the single-phase austenite.
其特点是合碳量低于0.1%，利用Cr、Ni配合获得单相奥氏体组织。I: The carbon content is lower than 304, so the strength is slightly lower.
L：碳的含量比304低，因此强度略低一点。Appropriate to increase the carbon content of manganese and add trace vanadium, titanium, niobium and other alloying elements, can greatly improve the strength of steel.
(C) The titanium content shall be not less than five times the carbon content and not more than 0.70%.
含钛量的标准不低于含碳量的5倍,并且不超过0.70%。In order to get a good overall performance for the parts, the carbon content is generally controlled at 0.30~ 0.50%?
为了获得调质零件的良好综合性能，通常将碳含量控制在0.30?We approximate roughly the carbon content of all combustible material in a city as 40- 60%.
我们估计，城市可燃物质的碳含量大约是40-60%。Incidentally, the"L" on the end indicates Low Carbon; reducing the carbon content has improved SUS316's poor inter-granular corrosion* properties.
顺便一提，末尾的“L”的意思是LowCarbon（低碳），通过减少含碳量，提高了耐晶间腐蚀*性，改善了SUS316的弱点。这两者最大的区别在于碳物质。The carbon content of 1020 steel can reach around 0.2 percent.
钢中的碳含量可达到约0.2％。Among the choices of white mold material for castings, one is that the carbon content is high;
在铸件白模模样材料的选择中，一是含碳量高；.In order to get a good overall performance for the parts, the carbon content is generally controlled at 0.30~ 0.50%.
为使调质件得到好的综合性能，一般含碳量控制在0.30~0.50%。If the furnace contains carbon monoxide or methane gas, it will also increase the carbon content on the surface of the metal.
如果炉中含有一氧化碳或甲烷气体，还会使金属表面增碳。
