Ejemplos de uso de Function selector switch en Inglés y sus traducciones al Español
{-}
-
Colloquial
-
Official
The function selector switch must be in Position 1 if the sensor is used as a room sensor
Press and hold the release button for the function selector switch 6a and turn the function selector switch 6 until the desired symbol locks in next to the arrow.
turn the function selector switch until it engages in the“Chisel adjustment” position.
The channel is the input selector switch for function block(FB) of the sensor.
Refer to Operation on page 4 for an explanation of the function of the selector switch.
Also, if you select a function with the selector switch M, this knob adjusts its quantity.
Note: If you select another measuring function with the selector switch(10) after calibrating,
select another test function with the selector switch 10.
Before changing functions using the selector switch, always disconnect the test leads from the circuit under test.
Set the function selector switch to the desired measurement range.
Turn the function selector switch until it engages in the“Chisel adjustment” position.
Set the function selector switch to the desired measurement range. 3.
Do not operate the function selector switch while the motor is running.
Set the function selector switch to the 200k position. 3.
To chisel, turn the function selector switch 6 to.
Setting the function with the function selector switch.
The module's function selector switch must be set to Position 6.
Set the function selector switch to“Hammer drilling”.
Turn the AUX/RADIO function selector switch(8) to the AUX position.
Microphone function selector switch(MIC) OFF.