Examples of using Inlet in English and their translations into Chinese
{-}
-
Political
-
Ecclesiastic
-
Programming
In the oil hole in the tube, so that the oil level is only slightly higher than the inlet;
The inlet gas stream usually enters the bottom of the tower and moves upward, while liquid is sprayed downward from one or more levels.
If the inlet pressure is too small(less than 1kg), a booster pump needs to be installed in front of the water purifier.
The J-10B is designed to carry an advanced electronically steered radar antenna, and employs an engine inlet design modelled on the F-35 Joint Strike Fighter.
The inlet stream typically enters the bottom of the tower and moves upward, while liquid is sprayed downward from one or more levels.
If the inlet pressure is too small(less than 1kg), a booster pump needs to be installed in front of the water purifier.
The new J-10C model, which reportedly entered front-line service in 2018, sports a new engine inlet that apparently reduces the plane's radar signature.
If the water temperature differentials between inlet and outlet are high, then a large external water tank would be used to store the cold water.
If the water purifier is not used for a long time, please close the water inlet valve of the tap water.
If these are covered containers, drill holes in the lid for the inlet and outlet water lines and pump power cable.
The little clump of land off the coast ofMassachusetts was hers, every hill, every street, every cliff and inlet.
The valve body containing one or more openings, called ports, for inlet and outlet, and the valve interior operating components.
The only people who regularly trek to the area are fishermen- the inlet teems with perch and pike and sun bass.
The idea is that a slot in the wing mirror allows air to flow through, thereby improving cooling into the inlet.
If the main valve is too large to open directly, this design will use the inlet pressure to open the main valve.
When the vehicle is powered, we install a fan into the model and analyze inlet lip separation and inlet distortion,” says Bykerk.
It is interesting to note that at 386 Hz, there is almost no transmission loss from the muffler inlet to the muffler outlet.
This includes the type of fuel that will be used, as well as data about the flue gas, including flowrate, composition, and inlet temperature.
This includes the type of fuel that will be used and data about the flue gas including flow rate, composition and inlet temperature.
Depending on the valve model, there is an inlet and an outlet to which the pipe must be connected.