Examples of using The pump in English and their translations into Chinese
{-}
-
Political
-
Ecclesiastic
-
Programming
To use plunger pumps, water must be located above the pump.
Moreover, the whole system does not need to start the pump, so it can start quickly and realize the stable operation of the vacuum system.
As a digital pioneer of the pump industry, Wilo will also be developing resource-efficient smart solutions to meet these demands.
Therefore, the working point of the pump should be selected within this range, rather than allow it to work for a long time under 25-30mmhg.
Damage to the pump or oil line blocked, cylinder leakage, after inspection, according to the circumstances excluded.
Otherwise, it will not only affect the pumping efficiency, but also cause severe vibration and noise when the pump is working….
(2) high-pressure pipeline filter(A): located in the pump outlet pipe, there is protection of pollutants do not enter the system.
Double screw pump as a positive displacement pump, the pump suction chamber should be closely separated from the discharge chamber.
Because the pump speed and the discharge pressure are adapted to the actual heat load, energy consumption is reduced even further.
If you have iTunes, you can subscribe to the Pump& Systems' podcast and listen to it here.
Whether the pump works normally, whether the valve switch is valid, whether the cooling tower or fan is normal.
Another interesting fact is that at the pump, you can use a credit card, however, limit the payment of 1,600 rubles.
(b) If the ambient temperature is below 0° C, the pump water should be released to prevent cracking.
In the overhaul should pay attention to check and adjust the pump side of the gap, if necessary, should change the pump. .
This is not to say that the pump discharge pressure will not rise any more.
If the surface of the pump and impeller is smooth(this surface is called a hydraulic smooth surface), the surface resistance is small.
Prime the pump(mainly US): to increase government spending to stimulate the economy.
This cycle is repeated, gradually draining the air in the suction line, allowing water to enter the pump and completing the self-priming process.
The pump can be used in all areas where leak-free operation and long service life as well as low energy consumption are important requirements.
