Examples of using Inductor in English and their translations into Danish
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Official/political
-
Computer
The GCB-95F comes loaded with the legendary Fasel inductor, which instantly gives you the sound of the classic 60s wahs that are considered the holy grail of wah tone.
The inductor was wound around a 8 X 32 bolt(about 3/16 diameter) and then removed by unscrewing the bolt.
This inductor is not too important
Inductor L2 is a radio-frequency shunt that decouples power
a reactor is especially an inductor.
The inductor was then streached to about a 3/8 inch length
Details construction your air core inductor using a McDonald's soda straw will be described in the next section.
The oscillator is a colpitts stage, frequency of oscillation governed by the tank circuit made from two 5pF capacitors and the inductor.
The inductor(L1) is made by winding two pieces of 24 gauge insulated wire,
L4 210nH inductor diameter 1.2mm enameled wire into the hollow coil diameter of around 6.5mm 8 turns around the length of 12mm 1 Mi.
Varactor diode D2, inductor T2, resistor R24,
The variable capacitor and your self-made inductor will vibrate at frequencies in the FM radio band 88 to 108 MHz.
Magnet wire(Radio Shack part 278-1345) was used to build the inductor but you can use standard solid strand 22 AWG gauge copper wire.
This current feeds into the base of the 2N2222 NPN transistor which is connected to your variable capacitor, inductor and antenna.
With the increase in battery capacity smoothing capacitors and inductor power increases the quality of the welding.
Note that inductor L2 is a hand-wound,
In tank circuits, the underlying physics is that a capacitor stores electrical energy in the electric field between its plates and an inductor stores energy in the magnetic field induced by the coil winding.
The coordinated circuit of expense that is constituted by inductor L2 and variable capacitors C3,
The coordinated circuit of expense that is constituted by inductor L2 and variable capacitors C3,
then used a properly calibrated RF network analyser to measure the inductance of the inductor I had created.