Examples of using Flat washers in English and their translations into French
{-}
-
Colloquial
-
Official
check that your water inlet hoses have flat washers at both ends.
Make sure washer drum is empty and flat washers have been placed into hose couplings.
Attach the support table to the outer front rail brackets with the screws, flat washers, lockwashers and nuts.
nuts, and flat washers to secure shield(B)
Attach bracket(E) to wheel guard using hex bolts(F) and flat washers C.
spring washers(EE) and flat washers FF.
check that your water inlet hoses have flat washers at both ends.
eight 5/16” flat washers, four 5/16” lock washers,
four(4) 6mm Flat Washers G-1.
test these fasteners we attached flat washers to the threaded end of the bolt
Spring washers(67) and Flat washers(63) on the Post.
using the two 1/4"-20UNC bolts(N), and two flat washers J.
and 2 fLAT wASHERS(b) into the rear-facing screw holes on the SEAT bACk bRACkET 12.
2 fLAT wASHERS(b), 2 SPRINg wASHERS(C)
Countersink the holes for the carriage bolt heads and flat washers under the board so that the bolt heads are flush with
to structure using four 1/4" flat washers and four 1/4" x 3" lag bolts not included.
Place flat washers on the hex head bolts(included)
carefully install selected screws through flat washers, shoulder washers,
Reattach unit to its mounting bracket with the two 1/2”-13 hex head bolts, flat washers and lockwashers previously removed. Position speaker
Remove the two 1/2”-13 hex head bolts, flat washers and lockwashers that secure the mounting bracket to the unit. Disconnect the lanyard