Examples of using The openflow in English and their translations into Japanese
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
But this is now substantially improved from the OpenFlow standard perspective.
OF-Config is a protocol for the management of the OpenFlow switch.
Actual flow entries registered in the OpenFlow switch are shown below.
Notification of the OpenFlow message reception from the Stp class instance.
Indicates the ofproto module that supports the OpenFlow version in use.
Specifies the buffer ID of the packet buffered on the OpenFlow switch.
When the OpenFlow switch's buffer is used, this is omitted.
Specifies the instance of the Datapath class corresponding to the OpenFlow switch.
Examples of CPSIs are ForCES[RFC5810] and the OpenFlow protocol[OpenFlow].
This section describes match, instructions and actions defined in the OpenFlow protocol.
Let's configure a link aggregation between the OpenFlow switch and Linux host.
To use OpenFlow 1.3, the OpenFlow 1.3 version is specified for OFP_VERSIONS.
Msg, the instance of the OpenFlow message class corresponding to the event is stored.
This is the Datapath class instance supporting the OpenFlow switch subject to flow table operation.
Buffer_id When received packets are buffered on the OpenFlow switch, indicates its ID.
When LACP data units are not exchanged during the specified period, the OpenFlow switch sends a FlowRemoved message to the OpenFlow controller.
If the destination MAC address is found, an entry is added to the flow table of the OpenFlow switch.
The OpenFlow application works within the Junos SDK to change the control plane to create more dynamic network programmability.
The OpenFlow overlay would be used to support new premium services and SDN applications on top of the underlay network.