Examples of using Load current in English and their translations into Russian
{-}
-
Official
-
Colloquial
voltage range from 2 to 220 V and load current from 1 to 120 A.
Set the load connection as LCD1 and specify the Load Current it will draw from the 5V supply- note that unit prefixes(for example, 500m to represent 0.5A) are supported.
The difference in load current distribution can be seen when comparing the Current Density of the LCD1 power network tracks between the original and updated load arrangements.
Voltage: 0V to 3Vdc referenced to ground Load Current: 5A max,
Annotation: Principle of load current shaping of LED driver without smoothing high capability capacitor at the input is considered.
one for each 5V pin and its associated load current.
When Q2 turns on, it removes base current from Q1 thereby reducing the collector current of Q1. which is very nearly the load current.
Whereas, in a traditional system the conductors have to be sized to take the load current and are far more numerous.
cell float voltage, load current, ambient temperature,
cannot cut off the load current and the short-circuit current,
commutating load current, protecting against load SC,
outside of the section, which uses load current phase angle and responds only to the active component of the short-circuit current(KZ).
breaking disconnected, load current/overload current in the power system. 2.
Rated voltage, V Maximum load current, А Maximum power,
appearing as a result of termoelektrodvi zhuschey power at nominal load current is equal to half the absolute value of the limit of permissible basic error STI shunt;
1000V of direct and alternate current with load current of up to 6300 А of any complexity and modernity for the
Purpose-powered display controllers for unmatched processing power, loading current and prior exams in no time.
please reset it according to the loaded current, to guarantee the safety of this equipment.
from small inductive and capacitive load currents up to the full short circuit current,
opens various load currents and overcurrent and the current limit fuse is responsible for the breaking of short-ciruit current. .