Examples of using Bowstring in English and their translations into Slovak
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
The bowstring must not in any way assist aiming through the use of a peephole,
Then it is necessary to install the bowstring(the lower support element)
arrow, bowstring.
The material used for the bowstring hemp or flax,
which ends with a shot- the arrow moves away from the bowstring.
barely noticeable to the eye movement of the hand pulling the bowstring.
hinges that hold the elements of support to the steps, Bowstring, stair stringers and special screws protruding spectacular design elements stair design.
hold your breath and release the bowstring Download APK.
An oversight is equally common when the archer's right hand moves behind the arrow immediately after the bowstring has been released.
stretching the bowstring, more superficially.
because he has to make less effort when pulling and releasing the bowstring.
The hand holding the bow in weight experiences the elasticity of the bow during the release of the bowstring and extension of the shoulders.
The shooter's actions to release the bowstring should be carried out in the direction of the plane of the shot, and the bowstring should go only from the chin.
Depending on wearing heavy armor, as well as waste stamina by pulling the bowstring.
Type of the third- a spiral staircase without a center pillar with a support on the spirally curved bowstring.
The bowstring tension should occur only from the firing line and only in the direction of the chosen target.
For this splice need an extra counter as a bowstring, made up of two parts, will be weakened.
Complete calm, harmony with the inner world will tell you at what point should you release the bowstring.
It is recommended to place the arrow on a bowstring only at a time when there are no people
Lower fastening wooden balustersdirectly to the steps, Bowstring, stringers or using podperilka with a groove corresponding to the size of the cross section balusters are made using special metal hardware- studs, screws, self-tapping screws.