Examples of using Static pressure in English and their translations into Spanish
{-}
-
Colloquial
-
Official
Static pressure resistance of greater than 30 bars
In a well designed straight diffuser there is an almost constant static pressure throughout.
The unit is factory set for standard static pressure(X4A) at the time of shipping.
lower external static pressure is required, reset the external static pressure by repositioning the adaptors of the PC-board.
The values of static pressure losses of individual elements(static pressure drops refer to inner diameter of 150 mm)
Be sure supply plenum static pressure is no greater than 0.4 in. wc
the NF-A9 provides higher static pressure and an even better airflow/noise ratio than its much acclaimed predecessor.
The 2-valve manifolds are designed for static pressure and liquid level applications;
Static pressure depends on grain type,
Do not exceed the maximum differential and static pressure ranges listed on the label of the MVS205 sensor.
When the static pressure setting was set from the remote controller,
Match the static pressure settings for the unit to that for the duct.
To check the latest static pressure setting, check it on the remote controller,
CFM is too low, external static pressure is high causing motor HP output to be below table value.
As static pressure acts on all sides in all directions,
If the actual amperage is below the nameplate value, static pressure is greater than design and air flow is too low.
Using the 10-32 x 1/2" screws provided, install the O/A static pressure sensor vertically to the sensor bracket.
This product requires a minimum static pressure of 30 psi(206.8 kPa)
Change the second code according to the external static pressure of the duct to be connected as shown in table 2.
External static pressure setting Settings for external static pressure can be achieved in 2 ways.