Examples of using Switch is used in English and their translations into Spanish
{-}
-
Colloquial
-
Official
When the manual drain switch is used, temperature may be higher.
This switch is used for microphone sensitivity adjustment.
The fourth stage of CHKDSK is only invoked if the/R switch is used.
Here, the switch is used in the three ways described above in Point 2.
This switch is used to shape the audio response to the operator's preference.
I 75-ohm termination switch This switch is used when an external sync signal is used. .
This switch is used to select the digital output bit depth,
This switch is used to change the mode of PHONO OUTPUT
Therefore the switch is used when the requirements are to switch off the vacuum fan during sweeping mode.
POWER SWITCH- The POWER switch is used to turn on the Resolv 80a's active electronics.
This switch is used to determine how the dock is recognized in the system at boot up stage.
This switch is used to assign the TAPE
The Output switch is used to select the signal that is sent to the Line Output.
This switch is used to change the overall frequency response,
Function Switch- This switch is used for changing the information display on the LCD.
Here, the switch is used to disconnect the starting winding of the motor once the motor approaches its normal operating speed.
The switch is used to adjust the cutting height in continuously variable positions.
When a thermostat or timer switch is used, connect at point marked“T” on Figure 4.
This switch is used to defeat the DDT compression used to protect against signal clipping.
This switch is used adjust the inputsensit iv i ty of the corresponding channels,