Примеры использования Linear interpolation на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
The nominal refrigerating capacity at -10C shall be calculated by linear interpolation of the capacities at -20C and 0C.
The set points shall be calculated by linear interpolation between the 1 Hz set points of the reference cycle.
the maximum speed permitted by the tyre manufacturer, a linear interpolation of the maximum load rating applies.
All data points recorded under paragraph 1.2. must be connected using linear interpolation between points.
penguin breeding chronology(Figure A5) using linear interpolation.
adjacent measured values, linear interpolation shall be used.
adjacent measured values, linear interpolation shall be used.
Mapping curve generation All data points recorded under paragraph 4.2.2. shall be connected using linear interpolation between points.
the compressibility factor shall be obtained by linear interpolation between the compressibility factors indicated in the table,
for 2011 family spoken language was taken, linear interpolation was used for the periods between population censuses.
Linearization: linear interpolation in 50 points(only via OM Link)
so they were randomly subsampled from one in four pixels and then a linear interpolation was used to convert these data to the 0.5 grid.
TortoiseBlame uses a linear interpolation between these colours according to the repository revision indicated for each line.
then Calculate the PM number limit values PN limitWHTC in/kWh applicable over the WHTC test-cycle using the following formula linear interpolation between the CI and PI PM number limit values.
γ(ratio of specific heats of the gas mixture), using linear interpolation to find intermediate values.
γ(ratio of specific heats of the gas mixture), using linear interpolation to find intermediate values.
Linearization: linear interpolation in 50 points(only via OM Link)
Linearization: linear interpolation in 50 points(only via OM Link)
Linearization: linear interpolation in 50 points(only via OM Link)
The error value between two entered adjacent correction points is calculated with linear interpolation.