英語 での The resistance value の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
For AC power sources, the resistance value that is connected in series with the discharge tube is small in comparison to DC sources.
Applying a logic low to the LOCK input allows the output resistance to change with VIN, and applying a logic high holds the resistance value indefinitely.
Printing on black conductive PVC film with conductive ink, the product has good conductive effect, and superior shading performance, The resistance value is 106-108 ohms.
At this point the insulating resistance value when checking the resistance value should be immediately 1MΩ and be 10 MΩ after 10 minutes.
When the circuit is in disorder, the PTC will generate heat suddenly, and the resistance value will go up to the high state, which make the circuit in the state of relatively"reaking up" to protect the circuit.
Because InSb is used for normal semiconductor magnetoresistive element, the resistance value largely depends on the temperature, but our products is Sn-doped with excellent temperature characteristics.
When the resistance value between terminal 1 and terminal 2 is measured by tester, the resistance value change even at the Extra segment part, but there is no change in the voltage.
When DC Calibration(Fine) is executed, the resistance value mounted on the DC Calibration board is measured with the connected digital multimeter and it is confirmed that it is within the reference value. .
From the characteristics shown in Fig. 4, when considering capacitors and coils as resistances, the resistance value(impedance) must be considered as a function of time(phase).
By controlling the direction of spin, it changes the resistance value of the device, and matches the size of the resistance value to the digital signals“0” and“1.”.
If you do not know the resistance value of any one of the four resistors, you can easily calculate it by using the above equation.
The resistance value is written{100*(1+tol)}; this can be written directly in the resistance value field when setting the resistance value. .
It can detect the Resistance value of Resistance wire in electrofusion fittings interior, eliminate failure due to Resistance wire damage after welding process.
For example, at 25°C, the resistance value of copper foil of width 3 mm and length 50 mm, calculated as follows, is 8.17 mΩ.
Nearly all of the resistance component of a high voltage power device is the resistance of the drift layer, and the resistance value increases in proportion to the thickness of the drift layer.