在 英语 中使用 Signal line 的示例及其翻译为 中文
{-}
-
Political
-
Ecclesiastic
-
Programming
For a general digital board, the power input line width can be 50 to 80 mils, and the signal line width can be 6 to 10 mils.
HH is a series of it, mainly used for power supply filtering, and the signal line is HB series;
MACD is going down keeping a fairly stable sell signal(located below the signal line).
Each signal line must be twisted together with the GND line(DIN/ GND, DOUT/ GND, CS/ GND, PWR UP/ GND).
The main disadvantage of differential signal lines is the increased PCB area.
Regularly check whether the power supply and signal lines are broken or bitten;
RS-485 is very convenient for multi-point interconnection and can save many signal lines.
Not adequately isolating sensitive lines and noise signal lines are often problems.
The signal lines and power lines should be introduced separately, the exposed part of the hose protection, does not affect the PTZ rotation.
Distinguish between power supply, signal lines, and data wire protection for varistors, because they should meet the requirements of different technical standards.
The main disadvantage of differential signal lines is that it increases the area of the PCB.
The RS-232-C bus standard has 25 signal lines, including one main channel and one auxiliary channel.
Distinguish between power supply, signal lines, and data wire protection for varistors, because they should meet the requirements of different technical standards.
Therefore, all of the RF signal lines as far as possible into a linear design.
Any signal lines do not form a loop, if unavoidable, the loop should be as small as possible;
(2) The power and signal lines of other equipment should be avoided in parallel with the input and output lines of the inverter.
Insufficient isolation of sensitive lines and noise signal lines is a frequent problem.
Inadequate isolation of sensitive lines and noise signal lines is a common problem.
Finally, the design uses several Maxim MAX14130 four-channel digital isolators configured to provide protection for additional SPI connections and specific signal lines.
Different signal lines have different wiring requirements, to classify all the special requirements of signal lines, different designs are not the same classification.