Primjeri korištenja Connection point na Engleski i njihovi prijevodi na Hrvatskom
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
paving breakers VVG-wire 3* 1.5 of raspredkorobok to the connection point.
that houses the connection point between the Air Force base.
are locked at their connection point in the corner.
For the purposes of voltage control mode, each HVDC converter station shall be capable of contributing to voltage control at the connection point utilising its capabilities,
junction boxes, connection point powerful home appliances such as electric stove,
The diagram represents the lower limit of a voltage-against-time profile of the voltage at the connection point, expressed as the ratio of its actual value and its reference 1 pu value before, during and after a fault.
On the other hand, if the graphic is inserted music CD into the unit through the connection point of the already prepared in the directory[/media] content CD immediately available for listening through appropriate applications.
The relevant system operator in coordination with the relevant TSO shall have the right to specify that a power park module be capable of providing fast fault current at the connection point in case of symmetrical(3-phase) faults,
The HVDC system owner shall ensure that the reactive power of its HVDC converter station exchanged with the network at the connection point is limited to values specified by the relevant system operator in coordination with the relevant TSO.
fluctuation of the supply voltage on the network, at the connection point, exceeding the level specified by the relevant system operator in coordination with the relevant TSO.
fluctuation of the supply voltage on the network, at the connection point, exceeding the level specified by the relevant system operator, in coordination with the relevant TSO.
Pu-1,15 pu 20 minutes The table shows the minimum time periods during which a power-generating module must be capable of operating for voltages deviating from the reference 1 pu value at the connection point without disconnecting from the network where the voltage base for pu values is from 300 kV to 400 kV.
A DC-connected power park module shall be capable of receiving a fast signal from a connection point in the synchronous area to which frequency response is being provided,
For the purposes of voltage control mode, the power park module shall be capable of contributing to voltage control at the connection point by provision of reactive power exchange with the network with a setpoint voltage covering 0,95 to 1,05 pu in steps no greater than 0,01 pu,
Show_Connection Points.
With common hardware sizes used on all connection points, roof construction is easier.
fix the connection points with a thin wire.
Add connection points.
Shorts unwanted continuity to other nearby connection points.
where pipes and connection points a little bit.