Examples of using Impedance in English and their translations into Hebrew
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
If the input circuit has an impedance to ground of Ri,
called electrical impedance, particularly in the branched wiring systems prevalent in aircraft.
often the ability to discharge the following transistor bases rapidly, and low output impedance to avoid or minimize distortion.
The GoWISE USA is designed in the USA and manufactured in China uses Bioelectrical Impedance Analysis(BIA) sends a small electrical current through your body measuring resistance at differing frequencies to give an estimated body fat,
multiple tap selector switches, but avoids creating high circulating currents by using a diverter switch to temporarily place large diverter impedance in series with the short-circuited turns.
often the ability to discharge the following transistor bases rapidly, and low output impedance to avoid or minimize distortion.
There are two choices in the literature for defining reactance for a capacitor. One is to use a uniform notion of reactance as the imaginary part of impedance, in which case the reactance of a capacitor is a negative number:[1][2][3].
power handling 800/ 2000 watts, impedance 2×4 ohms,
then the impedance is purely resistive; if X< 0{\displaystyle\scriptstyle X.
Because antennas that are much shorter than 1/4 wavelength present a very small and highly reactive impedance that is dependent on the received frequency, no attempt was
It is the imaginary part of the impedance: X= ℑ( Z){\displaystyle{X=\Im{(Z)}}}
Unfortunately I could not find technical information about the frequency range, impedance and sensitivity of dual drivers
The method, known as electrochemical impedance microscopy(EIM) may be used to explore subtle features of profound importance for basic
It asserts that a floating impedance element, supplied by two voltage sources connected in series, may be split into two grounded elements with corresponding impedances.
circuit that can be used to match a wide range of impedances in RF circuits.
Impedances look good.
The idea of Miller theorem(modifying circuit impedances seen from the sides of the input and output sources) is revealed below
When resistors, capacitors, and inductors are combined in an AC circuit, the impedances of the individual components can be combined in the same way that the resistances are combined in a DC circuit.
than the combination of any other impedances connected to the same output pin(usually just called“high impedance”).
Nominal impedance: 8 ohms.