Examples of using LED indicates in English and their translations into Spanish
{-}
-
Colloquial
-
Official
A flashing LED indicates that the device has been switched off.
Besides color LED indicates the status of the unit.
LED indicates power and data access status.
The Clip LED indicates a gain this reduction is higher than 12dB.
LED indicates status, mute status
Illumination of LED indicates status of amplifier.
On the controller, an LED indicates if an error occurs
This LED indicates that the internal A/D chips are correctly synchronised to the external clock signal entering the rear panel Word clock BNC connector.
SPLIT- When lit, this LED indicates that Split Cue mode has been enabled.
The CHARGE LED indicates the charging process(Red when charging,
Illumination of the LED indicates EFX Select Mode; a dark LED indicates Preset Select Mode.
The Signal LED indicates whether a signal is reaching
The flash sequence of the LED indicates the different operating states of the Aura BluNote.
If the LED indicates low battery power(indicator blinks green(yellow when SimulView mode) 3 times every 2 seconds), replace the battery.
After knocking on the diode meter that indicate the current level attained your goals, each LED indicates 20% of the target.
When the Power Switch is in the‘On'position, this LED indicates whether the subwoofer is in the On
Installing the LED Warning Light The LED Warning Light has three functions: The LED indicates that the Cycle Alarm is armed.
sensor, simultaneously or successively, until the LED indicates learning mode.
The LED indicates when you also need to replace the filter
Each LED indicates the parameter that may be adjusted by means of the knob O while the LED itself is lit.