Examples of using Calibration factor in English and their translations into Spanish
{-}
-
Colloquial
-
Official
Changes(pipe system or calibration factor) made after the zero calibration may affect the accuracy,
Continue doing this until the desired calibration factor is entered from 0.1% to 199.9.
The watch then calculates the calibration factor of the foot pod by comparing the distance measured with the actual distance you traveled.
The calibration factor is the amount of rainfall depth(mm,
The meter calibration factor is determined during factory test.
Decrease the calibration factor if your distance is too high.
Increase the calibration factor if your distance is too low.
Please stand by, while the system obtains the Zero Weight Calibration Factor.
The calibration factor is set to 100(percent)
The calibration factor is then applied to this total.
Manual calibration is recommended if you know your calibration factor.
Current total, unit of measure, and calibration factor are displayed.
You can also enter the calibration factor manually.
Input the calibration factor in mm or inches.
Calibration factor"out of range.
The calibration factor is determined by taking the kNOWN distance
Press the+ or- buttons to adjust the calibration factor to the average calibration factor calculated in Step 20.
The device calculates and displays the calibration factor on the second row of.
Alternatively, you can provide the calibration factor manually using the UP/DOWN buttons.
The calibration factor(the ratio applied to foot pod measurements to ensure accurate calculations) is automatically calculated.
