Examples of using Continuity test in English and their translations into Spanish
{-}
-
Colloquial
-
Official
The continuity test is always active
Station VII- continuity test and selective separation of the correct
During the ground wire test the control unit does a continuity test between neutral and ground.
Before performing a continuity test, make sure that the power supply to the circuit to be tested has been switched off.
To switch to continuity test, press the button“MODE”(3)
This compensation is obtained by holding down the HOLD key when the continuity test or measurement resistance function is selected.
Continuity sound test for a resistance≤ 40 Ω, and resistance measurements up to 40 MΩ The continuity test is selected automatically when the instrument is swiched On.
To run the check, the manual vacuum pump can be used to perform a continuity test on the output lines of the change-over valve.
The continuity test function, which complies with the IEC 61557 standard(200 mA current),
12 unipolar thermo-retracting junctions at the ends and continuity test, screen ohmic resistance of screens,
In particular, it is active in position CAP to select diode test, continuity test, capacitance measurement
In addition, it is suitable for continuity testing and rotating magnetic field measurement.
Continuity tests whether there is an electrical flow between the terminals.
It allows continuity tests in circularly systems(ring network)
For continuity tests set the rotary switch to position.
For continuity tests, a buzzer is provided.
ecometries and continuity tests) guarantee the full integrity of data along with detailed documents that are delivered to the client.
Continuity tests are probably the most frequently performed electrical troubleshooting procedures around the home.
Continuity tests are probably the most frequently performed electrical troubleshooting procedures around the home.
perform continuity tests and check cable labeling.