Examples of using Switch module in English and their translations into Spanish
{-}
-
Colloquial
-
Official
The switch module is delivered with FC 8G SFP transceivers installed in the four fibre channel ports.
left corner of the key switch module will be ON while activated.
From the switch module FOS CLI enter the following command for the ports being used this can also be enabled from the switch GUI.
the attached motor and switch module.
45 ports per switch module.
Press several times to ensure that the terminal connection is successfully established and the switch module can be configured through the CLI.
An internal serial management port provides access to the switch module through the DRAC/MC.
which store the IP address values on the switch module.
Remove the orange colored protective connector cover from the back of the switch module pull.
NOTICE: The DRAC/MC module and the network switch module(s) can be configured for DHCP.
The switch module is metal framed with 14 connection pins with 2 mm pitched.
Determine whether the Fibre Channel portion of the switch module is in NPIV
The switch module can also use active twin-ax copper cables on the 10G Enhanced Ethernet ports.
The switch module automatically reboots
Slide the switch module out of the antistatic sleeve
The switch module automatically reboots
Switch module to speed sync mode
the Dell M8428-k is referred to as the converged network switch or the switch module.
Substitute the correct value for switch-x where x is the bay where the switch module is installed.
Perform these steps to back up the switch module configuration to an FTP server.