Примеры использования Braking force на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
Piston stroke extends, and exceeding braking force limiting value declines.
The basic method used within the brake to generate the braking force;
P*: Hydraulic pressure in brake cylinder to produce the braking force B*;
Set braking force regulator according to the degree of loading of the load box does not apply to trans-shipment trailer equipped with braking system with automatic regulator.
All axels At least one axle shall commence to develop a braking force when the pressure at the coupling head is within the pressure range 20 to 100 50 to 80 kPa.
Automatic braking force regulator adapts braking pressure depending on the load of the trans-shipment trailer.
Braking force coefficient of a tyre(BFC)" means the ratio of the braking force to the vertical load.
If the braking force is regulated in steps,
Parking brake braking force(kN) 70 35 Difference between left
Peak braking force coefficient of a tyre" means the maximum value of a tyre braking force coefficient that occurs prior to wheel lockup as the braking torque is progressively increased.
The braking force is obtained by means of a spring that, through a suitable system of levers,
Instead of jerking the brake lever to the position where you think you will generate appropriate braking force, squeeze the lever,
The vehicle is equipped with a four-channel anti-lock braking system(ABS), braking force distribution(EBD), traction control(TCS),
The average peak braking force coefficient(upeak, ave)
This braking torque shall produce a braking force of at least the prescribed braking force B*;
Before driving off check that the parking brake is released, the braking force regulator is positioned in the proper position applies to manual three position regulators.
SECTION 3 Pronar T386 3.11 For systems with automatic regulator, braking force depends on trailer load.
Category B. The contribution of the electric regenerative braking system to the braking force generated shall not exceed that minimum level guaranteed by the system design.
The average peak braking force coefficient(upeak, ave)
continuously monitors the diameter of the master roll, and adjusts the braking force, to exactly match the current roll diameter.