英語 での Duty cycle の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
If it operates with a 50% duty cycle(equal time for transmitting and receiving), then RMS power into the PA is 0.6W.
Start-up FunctionThe drive method of start-up operation can be selected either duty cycle of 0% or 100.
Duty cycle is the effective portion of time in certain electroplating period with the current or potential applied.
The command and data in turn are used to set the frequency and duty cycle of the PWM.
When the output voltage reaches 5V, the PWM duty cycle drops to almost nothing.
In the absence of indications I was set with 60 gauss, 75 hertz, 50 duty cycle.
After titration in continuous wave mode(endpoint barely visible burn) and switch to 10% Duty Cycle with the same power as in titration.
Feasible and programmable: support adjustable data and clock duty cycle in high precision, to achieve wide range data transmission rate.
The astable configuration, with two resistors, cannot produce a 50% duty cycle.
D7 provides an ORing circuit that will allow the 10% duty cycle to propagate whenever the brake/turn input is not available.
As VIN increases past 8.5 V, the output will clamp around 6 V and the output duty cycle will reduce to about 40.
The controller also features internal softstart, bootstrap startup source, current-mode compensation, and a 78% maximum duty cycle.
Because the duty cycle is normalized in the transformer circuit(made closer to 50"), the controller can operate at a frequency N times higher for the same off-time.
The high-side P-channel MOSFET can operate at 100% duty cycle for lowest dropout voltage and does not require a bootstrap capacitor for gate drive.
This suggests that if the duty cycle is greater than 0.5, a higher voltage will be regulated at the output(boost); if the duty cycle is less than 0.5, the regulated voltage will be lower buck.
Availability- 24x7 design form low duty cycle, non-mission-critical applications in PC, nearline and consumer electronics environments, which vary from application to application.
The EV kit GUI allows to set the Coarse and Fine PWM duty cycle inputs to the MAX12900 to control the 4-20mA loop current with±1μA resolution.
When the input voltage has approached the output voltage, operation with a 100% duty cycle by the high-side P-ch MOSFET is possible, and so the input voltage can be supplied to the output via the high-side MOSFET and an inductor.
For 80A transients, the pulses are not package limited and, therefore, can last longer(up to 50ms), but the duty cycle for 80A transients should not exceed 3.
Undervoltage lockout, soft-start, switching frequency, maximum duty cycle, and overcurrent protection limit are all adjustable using a minimum number of external components.