英語 での Measuring time の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Measuring time doesn't make sense.
Measuring time About 0.5 seconds.
Measuring time in nondestructive method is 60 seconds.
Measuring time for content loaded before boomerang.
When the measuring time is reduced, the factory settings are also changed at the same time. .
The measuring time of the gas analysis can be reduced by the user.
A9: The measuring time is unlimited(depends only on available disk space).
Measuring Time: About 2.4s(Measure SCI& SCE about 5s).
Due to the short measuring time, important process parameters for the monitoring and control are available almost immediately.
It continues to claim its place as an instrument for measuring time rather than consuming it.
For natural days, which are commonly considered equal for the purpose of measuring time, are actually unequal.
The popularity of the brand began in 1983, when the clock ceased to be just a device for measuring time.
By digitalizing the workflows, SiteMaster Kitchen simply cuts both conversion time back in the office and measuring time on site in half.
Air was constantly supplied from the surface, and measuring time underwater was most likely not these men's first priority.
In general, when performing rotating speed measurements, if the gate time( measuring time) is specified at 1 second, using a 60 P/R gear enables direct readout of the rotating speed by the counter.
Blood Glucose Meter Description: 1. results are accurate 2. alarm reminder 3. 5 seconds measuring time 4. 0.5μL capillary blood volume 5.
There are lots and lots of ways of measuring time, but a really bizarre base 60 system known as hours and minutes and seconds is nearly universal around the world.
On 20 November 1754, he filed the plan for a Machine for measuring time at sea, in a sealed envelope that was never published[5].
With the development of this equipment, it became possible to perform quality evaluation of surface-treated Si substrates or cells with high-spatial resolution of one million pixels and a short measuring time of less than a second per sample.
There are techniques to evaluate solar cells at substrate level prior to cell fabrication, such as the microwave photoconductive decay method and surface photovoltage method. These methods are lacking, however, because of their long measuring time(tens of minutes per substrate) and insufficient spatial resolution several millimeters.