Examples of using Roughness in English and their translations into Arabic
{-}
-
Colloquial
-
Political
-
Ecclesiastic
-
Ecclesiastic
-
Computer
In addition, under the thin wallpaper is often clearly visible all the bumps, cracks and roughness present on the walls.
You see, at the high speeds for 5G the signal has to travel close to that roughness.
Didn't I just tell you that we needed that roughness to keep the device together?
and both surface roughness and dimensional inspection.
Clear the wall from loose pieces of putty with a spatula, sanded the rust on metal, remove burrs and roughness with wooden flooring;
FSZ(fully stabilized zirconia)with high density and good surface roughness.
A series of technical requirements are specified in the spindle part drawing, such as dimensional accuracy, shape and position tolerances, surface roughness, contact accuracy and heat treatment.
Must meet under the maximum production speed strip descaling requirements to ensure that after shot peening on the surface of the steel strip without residual iron scale, no dust, Sa2.5 cleanliness, surface roughness Ra is less than or equal to 2.5 mu m.
When the son came to Doha told us how they asked about his father with some roughness, and appeared on the island screens essential security analyst, it is highly appreciated by everyone.
Measurement of the surface is very smooth, the surface roughness Ra value usually 0.012 um, the distance between the two measuring surfaces is the working length of the ceramic gauge blocks(nominal length). The nominal length is 5.5mm ceramic gauge blocks.
So, too, it is possible the emergence of obvious creaks and rustling of sand or small pebbles,"buhtenie" ties, the emergence promyatyh plots surface roughness violation of the topcoat, and sometimes- and the apparent instability of a large fragment.
Wrinkle Roughness.
Roughness of R2.
Roughness above normal.
Surface Roughness: Ra12.5.
Commutator surface roughness Ra0.40um.
Previously on Necessary Roughness.
Improve roughness of surface.
Profilometers measure roughness height.
Roughness of cutting surface Ra12.5.