Examples of using Rated current in English and their translations into Polish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Financial
-
Official/political
-
Programming
-
Computer
RCDs connected in series after opening the machine, the rated current is less than the corresponding current installation breakers;
Rated current of this power supply is 1.5A,
Since the rated current is much lower than that of AB-breaker,
Although given for currents close to the rated current these relationships give a feel for how incandescent lamps work.
In accordance with the rules of the RCD is selected bysensitivity(10-30 mA) and the rated current, which is determined depending on the total capacity of all electrical appliances.
The selection of the the transformer load an no-load loss tester is selected based on the rated current.
The measured loss is the input voltage multiplied by the rated current multiplied by the power factor.
the current is adjusted to the rated current.
Recommend using a linear 12~15V DC and not less than the rated current of 1A linear regulated power supply.
The generated power loss value of the selected devices is calculated according to the actual application e.g. according to the rated current, coincidence factor, etc.
the vacuum circuit breaker can open and close the rated current.
the input voltage is gradually increased until the rated current is running for a period of time.
Good quality car lighter extension aligator clips Rated voltage 12 V DC Rated current 5 A Body material PVC.
According to the test transformer output rated current and rated voltage, can determine the capacity of the test transformer,
2-polar version for 6, 10, 16, 20 and 25A rated current.
male plugs with pin system from 3+PE to 24+PE with rated current from 10A to 23A.
Tungsten-copper contactor is suitable for using the circuit up to the rated voltage 660V AC 50HZ or 60HZ, rated current up to 95A,
especially not to exceed the rated current to prevent overheating.
of nominal value and insulation used in the selected device, the product must operate at a lower than rated current to ensure reliable operation over the desired temperature range.