Examples of using The stator in English and their translations into Swedish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
-
Political
Reprogrammable lock latches CS-RPR are supplied non-programmed with the rotor positioned in line with the index marked on the stator front surface.
For a long pump service life: a temperature sensor installed in the stator checks the temperature between rotor
For a long pump service life: a temperature sensor installed in the stator checks the temperature between rotor
reverse rotating magnetic fields in the stator of the rotating motor, resulting in a
Help against wear: with the stator tensioning device, a worn stator can be evenly retightened so that the original compression between the rotor and the stator is restored and the pump performs again at its full capacity.
position it can find, aligning its own magnetic field of the active coil on the stator.
Help against wear: with the stator tensioning device, a worn stator can be evenly retightened so that the original compression between the rotor and the stator is restored and the pump performs again at its full capacity.
This is because when the average temperature of the stator and rotor windings is measured electrically,
At a very basic level, AC motors consist of two primary parts: the outside part of the motor is known as the stator- the stationary part of the motor- which has coils that are supplied with alternating current to produce a rotating magnetic field;
This is because when the average temperature of the stator and rotor windings is measured electrically,
on the stator will generate an induction electric potential, if the stator and outer loop through to form a closed loop is to load the output current.
Silicone directly applied onto the back side of the stator head.
Direction… Two, turn the routers to the end in the direction of the stator Fit the knobs in a straight line with the screws.
In order to keep the iron losses at a reasonable level, the stator is wound from very thin iron ribbon,
rotor current remains stable, and the variation range should not exceed 1% of the test current; the stator voltage, current and power are also exhausted.